Humax Remote Control Code Change
- Switch on your TV set and the Humax product that you wish to change the remote code.
- Make sure that any other Humax products you have are in Standby or powered OFF at the mains.
- Point the remote control towards the remote control sensor of the target receiver - get close to do this so there is no breakup of the IR beam and check that a dirty OK and/or 0 button does not cause the PVR light to flicker: you need a solid 5 seconds of signal from your remote to make this work.
- Press and hold the 0 and OK buttons simultaneously for 5 seconds until the PVR button on the remote stays red.
- A message will appear on the TV screen: "You can change the remote control mode. Press a Numeric Key (<1> ~ <6>) to select the mode Current mode: Mode 1."
- Press a NUMERIC button (from 1 to 6) to select a different mode.
- A message confirming the change of Mode will appear on screen.