Sharp Service Menu Instructions

Most of our Sharp Service Menu methods require the use of an original remote, typically you can not do it with just the buttons on the front of the set. If you no longer have your remote or have damaged it, we recommend that you purchase a Replacement Remote before trying to enter the service menu.

LCD Sets 2017-2018

1. Press {Menu} button
2. Press {1} {1} {4} {7}

LCD Sets 2016

1. Press the Menu button and then the right arrow button on the your remote, and then arrow down to the Sound settings. Arrow right and enter the Advanced Audio Settings, and arrow down to the Balance section. Make sure it is set to 0.
2. Type "1969" on your remote. Your TV will leave the menu screen, and a green "M" will appear in the upper left corner of your screen.
3. Press the Menu button to access the service menu. The 'Factory' tab at the top will be highlighted in yellow.

LCD Sets

1. While the LCD is on, unplug the power cable.
2. Then while pressing the {INPUT} & {VOL -} buttons on the remote, plug the power cable back into the outlet.
3. When it powers up you will see a little "k" appear in brackets.
4. Then on the TV, press and hold {VOL -} & {CH -} down and release.
5. The Service Menu will be displayed.

Use {CH+} {CH -} buttons to navigate, Use {VOL+} {VOL -} buttons to adjust the value.

Other Sets (CRT)

1. Unplug the TV
2. Press and hold the {VOL -} & {CH+} buttons.
3. While holding the above buttons, plug in the TV.
4. The TV will turn on with the Service Menu displayed.

Use {CH+} {CH -} buttons to navigate, Use {VOL+} {VOL -} buttons to adjust the value.

Alternative Method

1. Press the {MENU} button.
2. Then press the {4} {7} {2} {5} buttons.
3. The Service Menu will be displayed.
   1. Use the {UP} {DOWN} buttons to select items.
   2. Use the {LEFT} {RIGHT} buttons to change settings.
4. To exit, turn the power off.

Sharp Projector Method 1

1. Press {UP}, {UP}, {DOWN}, {DOWN}, {RIGHT}, {LEFT} & {ENTER} buttons on the remote control.

Sharp Projector Method 2

1. Press {INPUT}, {UP}, {DOWN}, {ENTER}, {ENTER} & {MENU} buttons on the back of the Projector.
2. To exit the Service Menu: Press {INPUT}, {UP}, {DOWN}, {ENTER}, {ENTER} & {MENU} buttons again on the back of the Projector.